Talk:RepRapPro Tricolour extruder drive assembly
Revision as of 15:05, 24 April 2013 by HelloNewman (talk | contribs) (→Chapter order, BOM and confusing picture)
Chapter Order
The chapter "Idler Tensioning" mentions two screws that are introduced only afterwards in the chapter "Fitting the drive". Perhaps this needs some re-ordering... --Holgero 08:34, 6 April 2013 (UTC)
BOM
I only needed 5 M3 nuts, did I miss something? Or where is the sixth M3 full nut supposed to go?
--Holgero 10:34, 6 April 2013 (UTC)
Chapter order, BOM and confusing picture
I agree with Holgero about the "Idler Tensioning" chapter and the use of only 5 nuts.
I also find the first picture a little confusing. According to the text you are suppose to mount the two frame clips of the extruder onto the front piece of studding.
--HelloNewman 19:04, 24 April 2013 (UTC)