Welcome! Log In Create A New Profile

Mendel jig bar tolerance question

mattuwattu

Mendel jig bar tolerance question
September 16, 2010 07:24AM

Registered: 13 years ago
Posts: 40

Hi all, I've about 90% of the Mendel BoM together and I've just started building.

I have a quick question, the jig bar is quoted as having a tolerance of +/- 0.2mm on its length, how have you guys achieved this? Have you all been out and bought 300mm verniers?!

Cheers
Matt

Edited 1 time(s). Last edit at 09/16/2010 05:42PM by mattuwattu.

Reply Quote

nophead

Re: Noob question
September 16, 2010 08:29AM

Admin
Registered: 17 years ago
Posts: 7,879

No I just ignored the +-0.2. I don't see why it needs to be so accurate. It is just important that all the jigged distances are the same.

[www.hydraraptor.blogspot.com]

Reply Quote

pica

"mendel jig bar tolerance question" was: Noob question
September 16, 2010 08:39AM

Registered: 14 years ago
Posts: 149

Good question. Good answer. Bad topic title.

Anyway you could change that to "mendel jig bar tolerance question"?