Share your start-up G-code October 31, 2011 01:43PM |
Registered: 12 years ago Posts: 24 |
Re: Share your start-up G-code October 31, 2011 06:49PM |
Registered: 12 years ago Posts: 411 |
Re: Share your start-up G-code October 31, 2011 10:11PM |
Registered: 12 years ago Posts: 24 |
Re: Share your start-up G-code November 01, 2011 01:53PM |
Registered: 13 years ago Posts: 615 |
Quote
kevinkline4124
I manually move the M 106 command in the gcode to right before bridges or small shapes (M 107 will turn it back off). I am hoping to be able to make the process automatic at some point in the future.
start.gcode G21 ;metric is good! G90 ;absolute positioning G28 ;go home G92 E0 ;set extruder home end.gcode M104 S0 ;heater off G1 X30 Y10 F2000.0 ;go to dump area M84 ;motors off