Electronic boards

I have and tried ramps,sanguinololu and printrboard but I still can not get anything to work I need basic along with all and any help I can get

first, can you see the boards with your Arduino IDE over USB?

What firmware have you loaded?

Second, Can you move the stepper motors?

What have you tried doing, what has worked, what has failed?

Maybe post pics of your current setup and connections to your control electronics?



with this info, maybe someone can begin to help you sort it out.

You purchased three electronics, just to find none of them working? *ouch*

As all RepRap electronics work basically the same way, following the Gen7 setup might help. Starting about here: [reprap.org] There are a lot of troubleshooting hints, most of them apply to your electronics, too.

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Go to the reprap irc channel and ask for help there.

[www.reprap.org]