New delta. Need help with firmware setup

Hello, just building my delta printer and need some guidance with regards to firmware setup, and how to measure rods etc.

Need some help please

That's a tall order. I doubt you will get many taker on this post the way it's worded.

Try these suggestions

0. If you bought your kit from a company, see what support is available there. (LOL. Sorry, this is just a lame attempt a humor
1. Be specific in describing your problem.
2. Limit your post to addressing a single problem. Start a new post for each issue you need to address.
3. Provide details that would be important to know, like which delta printer, where you got it, what electronics, which firmware, what PC operating system, which host software, etc. The more we have to go on, the quicker we can determine a solution.

If you want to move quicker than the fourums, try the IRC channel. You can find a link on the reprap home page.