I've cobbled together a Home brew extruder with an Ex HP printer 7.5 degree Stepper.. geared down about 6 to 1 ..
But only running the whole thing with a 12 v PSU
Mechanically its works very well .. even with the 7.5 deg steps
The ramps/ Stepsticks seem to drive it without getting very warm, ( big heatsinks on the IC)..
but the motor does get quite warm almost uncomfortable in the hand ??
This is the motor ....
https://www.robocore.net/upload/attachments/datasheet_pm55l_048_hpg9_115.pdf
Even with the Driver board current turned down ?
Clues.. for a newbie..
C..
Edited 1 time(s). Last edit at 03/29/2014 05:20AM by ceedy.