so I can connect a Single 1 Axis 3.5A TB6560 Stepper Stepping Motor Driver Board to a ramps 1.4

thes eones?
[www.ebay.co.uk]

and then power the drivers with a 12v 10 amp 120w switching psu

and connect some nema 17s these ones > JK42HS40-1304F
POWERING THE RAMPS AND THE ARDUINO OF THE 5V USB

so need to find out which ramps pin for x and y for en- en+ cw- and cw+ - and not clk- / +

are there push on pig-tails for the x and y out-puts to the drivers - i am guessing its 2B 2A 1A 1B

Edited 4 time(s). Last edit at 06/03/2014 04:58PM by nobler.

Why use those stepper drivers instead of Pololu A4988's?

---

[3DKarma.com] - suppliers of quality, affordable 3D printer kits and filament for the UK market.

[www.youtube.com]

x and y with nema 23's @ 3.1a driven by this?
[www.ebay.co.uk]

24v 15a 360w psu.

pulse width stretched from 1 to 2

use the ppololup to drive the head

big machine 1m cubed one inch belts

Edited 1 time(s). Last edit at 06/04/2014 03:21AM by nobler.