Welcome! Log In Create A New Profile

Help with mistakes..

Posted by IOWOLF

IOWOLF

Help with mistakes..
May 02, 2016 04:21PM

Registered: 8 years ago
Posts: 7

Been lurking for a while until I got my tarantula and then I Have printed a few parts and some Crap.

I was wondering about if there is a " what you are doing wrong" page ?

Like what I am doing wrong when I get something that resembles a sponge all over, or are all parts spongy on the insides?

TIA

Reply Quote

stephenrc

Re: Help with mistakes..
May 02, 2016 04:28PM

Registered: 12 years ago
Posts: 548

In the Printing section, see the sticky "pictorial print issue identifier" thread. It should get you started.

Reply Quote

ggherbaz

Re: Help with mistakes..
May 02, 2016 04:33PM

Registered: 10 years ago
Posts: 1,401

well, you can find a lot of info here: [forums.reprap.org]

but can you elaborate some more? all printed parts unless you specify not to will have some infill inside that will variate from few lines to a full structure depending on the percentage and type used.

Can you post some pictures to better help you?

Reply Quote

IOWOLF

Re: Help with mistakes..
May 02, 2016 06:39PM

Registered: 8 years ago
Posts: 7

thanks I will try those.

Reply Quote

DjDemonD

Re: Help with mistakes..
May 03, 2016 08:52AM

Registered: 8 years ago
Posts: 3,525

The other place thats good is the Simplfy3d website [www.simplify3d.com]

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions

Reply Quote

IOWOLF

Re: Help with mistakes..
May 03, 2016 03:32PM

Registered: 8 years ago
Posts: 7

Quote
DjDemonD
The other place thats good is the Simplfy3d website [www.simplify3d.com]