I'm trying to set up dual extruders on my AZTEEG X3 board. I keep getting this error.
Error:Heating failed, system stopped! Heater_ID: 1
[ERROR] Error:Heating failed, system stopped! Heater_ID: 1
When I try to turn it on. I'm using Marlin firmware and I'm going through all kinds of pin settings for HEATER_1_PIN with no luck so far. Panucatt has absolutely no support for their products. I've had a ticket open for another question for 3 months. Can't get them to respond to anything.
When I have HEATER_1_PIN set to 9, the red LED by the terminal flashes weakly but I still get the error. Other pin settings don't even light up the LED at all.
I've swapped the hot ends and thermistors too and they both heat up on Heater 0 so I don't think it's the hot ends.
Does anyone else know what I can try?