Welcome! Log In Create A New Profile

Duet stop after 10 or 15mn

lolocaledo

Duet stop after 10 or 15mn
November 08, 2015 09:09PM

Registered: 8 years ago
Posts: 155

Hi all,

I have a strange behavior with my Duet.
All works fine however, with all my printings, after 10 or 15mn, the print stops ..... 10 or 15s without moves and then continue to print the job without error.

Any ideas about that ?

Laurent

Reply Quote

Koenig

Re: Duet stop after 10 or 15mn
November 09, 2015 02:50AM

Registered: 9 years ago
Posts: 445

Quote
lolocaledo
Hi all,

I have a strange behavior with my Duet.
All works fine however, with all my printings, after 10 or 15mn, the print stops ..... 10 or 15s without moves and then continue to print the job without error.

Any ideas about that ?

Laurent

Printing from computer or SD?

Reply Quote

lolocaledo

Re: Duet stop after 10 or 15mn
November 09, 2015 06:29AM

Registered: 8 years ago
Posts: 155

Hello,

Only printed from computer. I haven't tested the SD yet

Reply Quote

dc42

Re: Duet stop after 10 or 15mn
November 09, 2015 06:52AM

Registered: 10 years ago
Posts: 14,672

It probably means your computer busied itself with other things and stopped sending data for a little while. Most people with Duet-controlled printers control them via the web interface, and either upload files to SD card, or use the "Upload & print" button, which uploads a file to the SD card and then prints it. This frees up your computer to do whatever you want without affecting the print.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

o_lampe

Re: Duet stop after 10 or 15mn
November 10, 2015 05:03AM

Registered: 9 years ago
Posts: 5,232

AFAIK, the RRF firmware has a flow-controlled USB-port. ( If that's the right term for it )
What happens to the head/extruder, when data stream is interrupted? Does the head park somewhere else and the extruder retracts?
-Olaf

Reply Quote

lolocaledo

Re: Duet stop after 10 or 15mn
November 10, 2015 09:22AM

Registered: 8 years ago
Posts: 155

No, head stay where it stop, no retract ...
and my iMac does nothing else !
I'll try to print with file on SD card.

And on the PanelDue, status is "Idle"

Edited 1 time(s). Last edit at 11/10/2015 10:16AM by lolocaledo.