Hallo All,
I have big problims to config my mendel, i'm not a programmer.
I tray to make it work for 4 months now, but no results. so maby sombody can help my whit it.
My configuration is:
-First Gen. Mendel (printed by Adrian Bowyer)
-Wades Extruder
-mendel-parts hotend v6 for PLA ( mendel-parts thermistor)
-PCB headedBed MK1 ( 100K thermistor)
-Arduino mega1280
-Marlin Firmware
-Pronterface
-Ramps 1.4
-LCD [
tommyc-reprap.blogspot.nl]
-SDramps ( not connected yet)
I don'n now what to do, i tray everything in my knowledge.
Its connect good whit Pronterface. but i dont have temp. readings, the 4 steppers don't want to move
The only thing that i can do is to put the extruder temp on and off
That is it
Can sombody please help my
Thank you all
First Gen Mendel made by Adrian Bowyer
Controller: RAMPS 1.4
Extruder: Greg's Wade Universal Accessible Extruder
Firmware :Marlin
----------------
MendelMax extra groot
RAMPS 1.4 grafisch display (diy)
Marlin
E3D v6
220V hotbed (diy)
Lang niks in 3Dprinting gedaan, begin nu weer hobby op te pakken.
Weer begonnen met:
Prusa Graber i3 "wood"
RAMPS 1.4 (mks tft28 v1.2 smart touch)
Marlin
E3D extruder v6 lite
