Welcome!
Log In
Create A New Profile
Home
>
Firmware Folder
>
Firmware - experimental, borrowed, and future
> Topic
Advanced
How do you configure Teacup with an Atmega328p?
Posted by
elimitator
Forum List
Message List
New Topic
elimitator
How do you configure Teacup with an Atmega328p?
November 13, 2011 08:14PM
Registered: 12 years ago
Posts: 10
Iv run into lots of errors which i have explained in a different thread
here
. Any help would be GREATLY appreciated.
Reply
Quote
Traumflug
Re: How do you configure Teacup with an Atmega328p?
November 14, 2011 05:04AM
Registered: 13 years ago
Posts: 7,616
You don't even tell us which hardware you try to get running. "Stepper Motor Driver 1.2" hints to a Generation 3 Electronics, an ATmega328 is used in none of the RepRap electronics.
Generation 7 Electronics
Teacup Firmware
RepRap DIY
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login