Hi All, I'm new to RAMPS and Marlan so please excuse my total noobieness.
I'm just setting up RAMPS 1.4 using Marlan and I am only in the testing phase. My extruder is pulsing, instead of just running from the control panel in replicatorG. I am guessing that it has something to do with commandPeriod but I have no idea where that came from.
Thanks for any help on this.
Jim
20:06:39] sending: N91 T0 G1 E8.075 F255 *97
[20:06:40] sending: N92 M114 *60
[20:06:40] Unknown: x:0.00y:0.00z:0.00e:8.07 count x:0.00y:0.00z:0.00
[20:06:40] sending: N93 T0 M105 *121
[20:06:40] sending: N94 T0 M105 *126
[20:06:40] motorSteps=200.0
[20:06:40] commandPeriod=100
[20:06:40] sending: N95 T0 G1 F255 *36
[20:06:40] sending: N96 T0 G1 E8.5 F255 *97
[20:06:41] motorSteps=200.0
[20:06:41] commandPeriod=100
[20:06:41] sending: N97 T0 G1 F255 *38
[20:06:41] sending: N98 T0 G1 E8.925 F255 *100
[20:06:41] sending: N99 M114 *55
[20:06:41] Unknown: x:0.00y:0.00z:0.00e:8.93 count x:0.00y:0.00z:0.00
[20:06:41] sending: N100 T0 M105 *66
[20:06:41] sending: N101 T0 M105 *67
[20:06:41] motorSteps=200.0
[20:06:41] commandPeriod=100
[20:06:41] sending: N102 T0 G1 F255 *27