I'm trying to get the right configuration for the teacup firmware. I'm using Generation 3 remix electronics and working on a lasercut mendel from reprapcentral.
I changed:
AD595 to Thermistor (as gen3 remix requires)
Downloaded a previous version of Arduino as suggested here: [
reprap.org]
added the Sanguino board
in the Make file: configured the path suggested for the avrdude as suggested in the above link
changed the programming protocol to StK500v1
Uploaded the changes
Changed the Baudrate on Repsnapper to fit 115200 like the firmware suggests before connecting the printer.
I get a temp reading thats way off (about 700-800 degrees) and no axis movement
Does anyone have any ideas??