Welcome! Log In Create A New Profile


Teacup is small and beautiful, but...

Posted by terrapin 
Teacup is small and beautiful, but...
February 05, 2014 04:03PM
Just test compiled both Teacup and Marlin in Arduino and found that Teacup has a really small foot print: .hex file about 18K. My question is whether Teacup supports Delta Printers or is there any plan to do it?

I am tempted to test it on Atmega328 (I know, it doesn't have enough pins, but..) just for fun.
Re: Teacup is small and beautiful, but...
February 14, 2014 11:11AM
I just got teacup to compile for rambo, and 2560 chipset. it still needs pin assignments. after i test the motion, I'll try to implement delta motion, at least well enough that someone else can do it better.


it compiles but pin assignments have not been verified as of yet. it is a copy of the 1280.h and the gen7 config file, also error traping for cpu has been removed and needs to be replaced. give me some time.
Sorry, only registered users may post in this forum.

Click here to login