Welcome! Log In Create A New Profile

Advanced

Com Problem Simplify3d

Posted by Mauxx 
Com Problem Simplify3d
November 17, 2019 06:54AM
Hello,

I'm using RRF on SKR v.1.3
It work, but the only way to move printer with Simplify3d is run Arduino Ide and give a command like M106 S255, then close it and open Simplify

What is the problem?

Edited 1 time(s). Last edit at 11/17/2019 08:11AM by Mauxx.
Re: Com Problem Simplify3d
November 17, 2019 08:47AM
Try setting flow control in the S3D comms options settings to Hardware.



Large delta printer [miscsolutions.wordpress.com], Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Re: Com Problem Simplify3d
November 17, 2019 11:02AM
Thank you @dc42, i'll try
Sorry, only registered users may post in this forum.

Click here to login