Hello!
I would like to build Mendel with Gen7 electronics, but i get lost if i don't follow any instruction.I would also like to etch the circuits myself.
Do you know if there is any page where it is explained as clear as in [
reprap.org] to build Mendel but with modern electronics?
By the way I've downloaded :
Traumflug-Generation_7_Electronics-release-1.3.1-32-gd16944f.zip
And I can see : Gen7Board.back.gbr , in violet, this is what i have to print with the laser printer to etch the circuit ?
Thanks,
regards, David.
Edited 1 time(s). Last edit at 03/09/2012 06:11PM by Davsp.