Hi all,
First off apologies if this post is in the wrong place - moderators please move if there is a better place for it.
So a few years ago I bought and built a Mendel, and it successfully printed one or two very small basic items. I then encounter some issues when trying to print bigger items and had a bit of a play to try and fine tune the machine but with very limited knowledge i kept going backwards, which then ended with the Mendel being left in the corner and its not been touched since.
It seems a waste to me to have it just sitting there and would very much appreciate somebody spending some time with it to make it print properly, set up the software and fine tune the machine etc - I would of course pay the poor soul for their time and efforts.
As mentioned its a Mendel with Gen 6 electronics and an Aluminium print bed, i do have a heated bed but its not got any control device. Built to take ABS but happy to swap to PLA if it makes things easier, and have been using Skeinforge to create the G-Code.
I'm based near Peterborough but am happy to travel to most places and leave the printer with someone for however long it takes!
If anyone is interested then my best port of contact is via email:
andrew_butter@hotmail.com
Many thanks, Andrew
