Hello,
I am new to this forum and 3d printing.
If I am in the wrong section please let me know.
I am building a Prusa i3 printer.
I have completed most of the frame and fitted the stepper motors.
Before I go any further I am seeking a bit of advice.
Firstly, which controller is the best, easiest to use.
The weak part of my knowledge is the software, so any help will be appreciated.
Next question, what diameter printing material is best.
I am shortly going to make the Hot end so I need to make it to suit the diameter.
On the same subject is there any agreement on the best Hot end design.
Thanks
Tony