Hi everyone,
i still have a sells mendel and after lots of calibration issues (mostly x backlash do to friction), i now have very nice looking and dimensional accurate prints.
I print the infill with 60mm/s and the perimeters with 24mm/s with abs and a grrf hotend on wades extruder.
Whats your speed settings for the good old sells mendel? How fast do you go without loss in quality?
My acceleration settings are
DEFAULT_MAX_ACCELERATION {3000,3000,100,10000}
DEFAULT_ACCELERATION 600
Could i adjust these settings too?
Best,
Ljundsberg