GCode stuck?

Ey everyone.

After assembling my reprap I got stuck with some software problems.
After finally getting the computer to read te right port I got the error as seen in the attchement.
To be precise, I don' t think it is an error, but when I start the reprap I get this window. Everything goes fine until the first Gcode is send, then the program just waits (for responce I guess).
I tried reloading the firmware (I found a reprap mendel 10110509 pack and after some code ajustments I got it to upload.)
I can't find anything else that may help.

To be a little more precise:
- I' m using a mendel pursa.
- Windows XP, java RE 5
- I have anguino with sanguino software on my computer.
- I use reprap host.

Please help, I'm getting a litlle bit desperate after 2 days of debugging....

Greets,

Joran

See "Host software not working with FTDI cable?".
Chances are that the baudrate in your firmware does not match that set in the Host software.
Make sure that they are identical!

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Tanx, that solved it, the program will load now
Now i only have to figure out why it freezes everytime i try to give an move error at the xyz tab....