I'm trying to get my bridges to print better. The settings under Speed (Bridge flow / feed rate multiplier) have no effect on the gcode that comes out though. I've verified that the layer
is interpreted as a bridge (at least, it's just a bunch of parallel lines in the direction of the bridge), but no speed changes show up.
If I manually go into the gcode output and slow down my bridge layer's feed rate, I get great results, but I don't want to have to manually tweak the file whenever I'm printing a bridge.
Any thoughts as to what might be happening, or how I can address it?
Edited 1 time(s). Last edit at 01/07/2012 11:05PM by shrikel.