Welcome! Log In Create A New Profile

My Skeinforge generated g-code isn't extruding anything.

Posted by keavon

keavon

My Skeinforge generated g-code isn't extruding anything.
February 06, 2011 01:51PM

Registered: 13 years ago
Posts: 15

Hello. The title says it all. The extruder motor isn't running. How can I fix this? I accidentally found an answer to this sometime last week, but I can't find it anywhere including in my browser history. Can somebody help me? Thanks!

Reply Quote

keavon

Re: My Skeinforge generated g-code isn't extruding anything.
February 06, 2011 02:00PM

Registered: 13 years ago
Posts: 15

I am using RAMPS V1.2 with the firmware johnnyr-Tonokip-Firmware-933c0b6
I have been using RepSnapper and it works fine, but it simply doesn't turn on the extruder motor for it. Any ideas or settings to change?

Reply Quote

AgeingHippy

Re: My Skeinforge generated g-code isn't extruding anything.
February 07, 2011 05:18AM

Registered: 13 years ago
Posts: 482

Does the gcode contain extruder commands?

Have you got the Dimension plugin activated?

Reply Quote

keavon

Re: My Skeinforge generated g-code isn't extruding anything.
February 07, 2011 06:10PM

Registered: 13 years ago
Posts: 15

Yes, I activated it and it's fixed now. But now I just need to fix a few settings. Skeinforge is SO complicated!