Hello all,
Hopefully someone can help point me in the right direction. I followed the instructions on the reprap wiki to download and install the Marlin firmware on the sanguino for my Huxley. The upload had no issues, and the motors seemed to be working fine, but I am having troubles with my hot end and bed.
The thermistor readings from pronterface are showing negative values, which I am assuming is because I need to set the beta values correctly, However, neither the bed nor the hot-end are heating up either way.
I have set the basic configurations in the source code file, but I must be missing some sort of proper thermal settings. I know it is just the chip as borrowing a chip from another Huxley fixes all these problems.
If anyone can help point me in the right direction I would very much appreciate it!