Hello all,
This is my first time working with a 3d printer. I bought a Prusa i3 with the 1.3a board on it. I've put it together, plugged my board to the USB, installed Arduino 1.0.5 and copied the sanguino folder to its hardware folder......Now i dont know where to go from here. My computer doesnt recognize it, my motors don't go whiiirr.... and unlike the previous topic, I DO get an LED light when the USB is plugged in. I cant find a good source of instructions that gets me from after building it, to calibration. Can someone help me figure this out?
Also, How can I see if theres actually power going to the board? I get 11.45v coming out of the power supply.
NVM about the last question. LED comes on when power is applied.
Thanks in advance.
Edited 2 time(s). Last edit at 05/19/2013 02:51AM by g0t0.