I almost Finish My new Prusa Mendel 2

i need Help with this End Stop , I know its common problem and i read thousand of replies but i did not really understand how to connect it to my

Ramp 1.4 using 3 pin

1-

A-3 PIN Cable -------(Red - Black - Blue )
B-RAMP1.4 Board (S, - , + )
C- Sprinter


2-

Is there any changes in the Configeration.h file i have to make it ?

3-
This Picture show my End Stop With the


Edited 1 time(s). Last edit at 09/20/2013 03:57AM by xblack0.

Your pcb and plug wont mate!

The pcb header from top to bottom looks like its wired:

logic
gnd
gnd
v+

Your cable is wired:

v+
gnd
logic

Maybe you can find a four pin connector from an old PC or something and swap the housings over by lifting the tabs and puling out the crimped wires.

---

=======================================================
A wise man once told me "Never trust a man who doesn't own a shed!"
=======================================================
Gen 6 daughter board
[forums.reprap.org]
Mendel PCB heatbed
[forums.reprap.org]
=======================================================