Tutorial: Burning the Sanguino Bootloader to the ATmega 644P using an Arduino. For use in Sanguinololu.

I wrote up a nice tutorial on burning the Sanguino Bootloader to the ATmega 644P using an Arduino as ISP.

You can find it here [reprap.org]

---

Charles Gantt.
Build blog [themakersworkbench.com] <---- my personal site
Build worklong [www.thebestcasescenario.com]

Great tutorial, Charles! Thank you.

This is no way limited to the Sanguinololu, though. It applies to virtually all ATmega and ATtiny based electronics, even the Arduino it's self. Perhaps it's a good idea to give the page a better name?

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Thanks Traumflug

I have already been asked to write up a similar tutorial re flashing the bootloader to the Arduino Mega's. Apparently a lot of people have been popping up in the IRC with issues with them. So maybe it will encompass all of the AVR Variants. I more or less wrote this one to help out those who are building a SL and had no idea how to burn the bootloader, because all of the info I found was either incorrect or incomplete.

---

Charles Gantt.
Build blog [themakersworkbench.com] <---- my personal site
Build worklong [www.thebestcasescenario.com]