Welcome! Log In Create A New Profile

Geeetech Rostock Mini G2/G2S - Assembly Tips & Modifications

Posted by Ezrec

Ezrec

Geeetech Rostock Mini G2/G2S - Assembly Tips & Modifications
September 06, 2015 09:26AM

Registered: 9 years ago
Posts: 127

I've recently acquired a Geeetech Rostock Mini G2S, and thought I'd share some of the assembly tips & modifications I've developed.

I've added them to the RepRap Geeetech Rostock Mini G2/G2s wiki page.

Enjoy!

Reply Quote

Ezrec

Re: Geeetech Rostock Mini G2/G2S - Assembly Tips & Modifications
September 06, 2015 09:45AM

Registered: 9 years ago
Posts: 127

And if anyone is wondering, my assembly time (first delta printer ever) was only 7 hours from unboxing to power on, even with the mods I had to figure out myself.

It's a nice kit - now just to get my Repetier firmware configured...

Reply Quote

Ezrec

Re: Geeetech Rostock Mini G2/G2S - Assembly Tips & Modifications
September 08, 2015 11:42AM

Registered: 9 years ago
Posts: 127

Configured, prints being made.

Wiki page updated with some additional modifications to eliminate belt jams on the towers.

Reply Quote

Ezrec

Re: Geeetech Rostock Mini G2/G2S - Assembly Tips & Modifications
September 13, 2015 08:07PM

Registered: 9 years ago
Posts: 127

.. Updated with advice on cabling the endstop signals, and a Repetier 0.91 config.