Welcome! Log In Create A New Profile

Anyone know how I should fix this wall issue?

MrMeeeseeeks

Anyone know how I should fix this wall issue?
September 06, 2015 09:41PM

Registered: 8 years ago
Posts: 35

My walls sometimes do this and I'm wondering what I need to do to fix it. I think I need to turn up my extrusion. Using Slic3R

7BvIIxX.jpg

Reply Quote

MrMeeeseeeks

Re: Anyone know how I should fix this wall issue?
September 06, 2015 11:02PM

Registered: 8 years ago
Posts: 35

Also to note. I'm seperating the wall with my finger. My prints look fine, its just the walls are loose.

Reply Quote

Koenig

Re: Anyone know how I should fix this wall issue?
September 07, 2015 12:24AM

Registered: 9 years ago
Posts: 445

Quote
MrMeeeseeeks
Also to note. I'm seperating the wall with my finger. My prints look fine, its just the walls are loose.

There's a setting in your slicer, "infill/perimiters overlap" (sli3r), try upping that.