Hi! Got a new delta. Loved the build. Its an Anycubic plus.
Problem im having.
When i send Home to the printer (code or on the interface). It doesnt go up. It goes down. But it doesnt try to home. Each motor in turn lowers a few mm. Then if i press it again, the same thing happens?

Endstops report triggered even though they're physically not? Maybe run M119 and see?

Wow. Çheers! Z min open. X y and z max triggered.... how bizarre.

Most likely cause?

Firmware is preconfigured by the supplier.... but wonder if its wiring or config....

Thanks in advance

J

All triggered. Wiring issue. Im such a tool. Did it according to the board instead of the config. Doh!

Life saver!
J