Zatsit, a multi-innovant delta 3D-Printer

I opened a post about a very original 3D-printer (really!)
[reprap.org]
But since it's also a delta, I might as well have posted here...

Looks very innovative. I especially like the water-cooled hotend, simple. Will you sell the hotend separately?

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions

Bonjour Marc (I assume that's you?)

Love your innovative ideas. Tired of worn out rodends, magnets and all that stuff...

and I also love your choice of music of the assembly videos! Watched one without sound, then saw the note that it is Astor Piazzolla! Watched it again with sound

This would be my next printer if the build volume was a bit larger. Looking for 250 dia and 400-450 height... would you consider that possible?


Best regards, Philipp

Hi Philipp !
Zatsit could be smaller, or bigger, and probably will one day. But first I have to bring this project to fruition, with a bed dimension that is compatible with most of the market.

Glad to finally find someone who likes Piazzolla! All I've had so far is comments that the music was atrocious! Piazzolla, atrocious!