AutoCalibration Yields No Results

Hello All!

I inherited a Kossel Mini (think3dprint3d) from a buddy who didn't have time to finish it. I finished wiring it up today and am running the following:

Firmware Name: RepRapFirmware for Duet
Firmware Version: 1.21.2beta1 (2018-06-23b1)
Web Interface Version: HTML: 1.11, JS: 1.11

When issuing the G32 Command or Pressing the "AutoCalibrate" button in the WebUI I am not getting any results in the logs other than "G32". I've checked that "Log Any Successful Gcode" is selected, but it has made no difference. Anyone have any insight into what might be happening? I'm not entirely clear one what controls the "reporting" mechanism, as there doesn't seem to be anything in the bed.g file which points me in that direction.

If your Mini Kossel uses the IR sensor Z probe not the mechanical one, delete the deployprobe.g and retractprobe.g files from /sys on the SD card if they are present.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Will try that, it does have an IR probe. Will reply with results :-D

Confirmed, dc42's suggestions of removing the two superfluous .g files worked!