Welcome! Log In Create A New Profile

Advanced

New config tool crashing delta

Posted by USSCody 
New config tool crashing delta
August 29, 2019 08:23AM
Carriage 3 repeatedly crashes into endstop on home

Anybody else?
Re: New config tool crashing delta
August 29, 2019 03:43PM
What electronics and firmware are you using?

The problem could be a configuration error, or wiring. Test the endstops (one way is to use M119) and verify that the endstop switch connected to the X endstop input is on the same tower as the motor connected to the X motor output. Similarly for Y and Z.

Edited 1 time(s). Last edit at 08/29/2019 03:44PM by dc42.



Large delta printer [miscsolutions.wordpress.com], Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Sorry, only registered users may post in this forum.

Click here to login