I'm off on the adventure of making a Gen 7 board. So far so good, I'm waiting for a few more components and I should be ready to start loading the bootloader and firmware - fingers crossed.
But, I can't seem to find info on the many pins on the board. Heater and temp are pretty straight forward, but what are the pins for the stepper motors and endstops? I must be missing something obvious.
For the endstops it's pretty obvious what's signal, what GND (light blue) and what 5V (thick red). Motor connectors are the same as with all other electronics: one motor coil on the left pair, one on the right pair.
Thanks. It is pretty obvious, but I just wanted to make sure I didn't cook a motor, driver, or board. Also, they're still in the mail, but it looks like the Pololu drivers are very clearly labeled also, so all is well. Thanks!