Temperature Sensor Initialization

Greetings from Mumbai!

I have a brand new Portabee 3D printer of which I just completed assembly. I am trying to initialize using 'First Run Wizard' - the hot end heats up and there is a temperature reading as well, from which I concluded that the thermistor is doing its job. However when the temperature reaches 50C in some cases or 70C at other times, I get an error message saying 'Temperature Measurement Failed'. How do I fix this problem and complete the initialization? Can I print in this condition?

I am using Cura 13.06.4.

Regards
Raghu Ramachandran

Edited 1 time(s). Last edit at 08/09/2013 03:52AM by raghu.

Hmm,
try using proterface and set the temperature to your requirement?

Thanks, nozzle set point and motors work with Pronterface!

Hoping to get some printing done soon ..

Raghu