Ramps 1.3 and PS_on ?
Posted by Skunky
|
Ramps 1.3 and PS_on ? February 25, 2013 03:39PM |
Hello.
I was wondering if it was possible to use the PS_on feature with a ramps 1.3 ?
as far as i understand, 1.3 and 1.4 are much alike, so i figured it should also be possible with a RAMPS 1.3 ?
Hope someone can help here
I was wondering if it was possible to use the PS_on feature with a ramps 1.3 ?
as far as i understand, 1.3 and 1.4 are much alike, so i figured it should also be possible with a RAMPS 1.3 ?
Hope someone can help here
|
Re: Ramps 1.3 and PS_on ? February 25, 2013 04:30PM |
Cefiar Wrote:
-------------------------------------------------------
> Should work fine. The output comes from the same
> Arduino pin on 1.3 and 1.4, so if someone
> hardcoded stuff in the firmware (rather than using
> the pin name PS_ON), their code should still work
> too.
Thanks for the reply.
Could you specify wich pins i need to use then ?
-------------------------------------------------------
> Should work fine. The output comes from the same
> Arduino pin on 1.3 and 1.4, so if someone
> hardcoded stuff in the firmware (rather than using
> the pin name PS_ON), their code should still work
> too.
Thanks for the reply.
Could you specify wich pins i need to use then ?
Sorry, only registered users may post in this forum.