4 axis

Hi guys I'm looking for help to run a cnc hot wire cutter I need 4 axis system has sd and lcd hoping to use this and put g code on sd and run it from there ? All up and working marlin

So what is the question ? I don't get it.

Maybe you misplaced the post, as this is the 3d printing forum ?
Is your system not working or do you still have to build one?

Anyway, you can build any reprap, replace the extruder with a Dremel and get milling :-)
Or you can build a CNC miller from another source.

Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Sorry for the confusion
Iv made a cnc foam cutter that has 4 independent axis I'm trying to use Ramps to run it but finding the 4 th axis difficult
And running g codes that prontface will run ?

Normally the 4th axis is the extruder in our world.
Pronterface will probably run every Gcode, as long as the axis support them.

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Are ok then I need to setup firmware some how with basically two mirror axis as your extruder settings differ from main axis