Good day all
Have been printing from my reprap full graphics smart controller due to my wife using the tumble dryer and my prints will stop when connected to my pc.
It`s been working great - I slice my object with simplify3d or slic3r - send the gcode to my sdcard and print from my screen.
Have one issue - my bed temperature are set to 45 for 1st layer and 40 for the next layers in my slicers start gcode.
When I print from my graphics controller the extruder are the correct temp, but my bed will show 45 setpoint and actual 45 for the 1st layer, but for the second layer it shows 40 setpoint(which is correct), but the actual temp still shows 45 and sometimes jump to 39 and immediately back to 45.
If I use my temp gun on my glass, it reads around 48 for 1st layer and 43 from the second layer.
Any ideas what is going on?
