Damn, this only got posted to the FVReprap facebook, and it is later today;
Here's a couple of important things that you need to know for Vancouver Mini Maker Faire. We're less than 3 weeks away from the event; I hope you're not all going too crazy!
1 - Maker Crew List
Please use this form to let us know who will be part of your crew, helping you out at your booth for the event.
2 - Maker Information Meeting
It's time for another Maker Town Hall, this time at the location of the event; the Forum building at the PNE on Saturday June 9th from 3-5pm. I don't expect it to go the whole length of time, but we have the time should we need it. We will mainly be touring the facility, going over the floorplan, and discussing the check-in, load-in/setup, and tear-down procedures.
The Forum building is located in the south-west corner of the PNE (right under the pin in the above map), at the corner of Hastings St and Renfew St. I expect that we will be entering through doors on the west side of the building next to the loading ramp (I will let you know if this changes).
From downtown head along Hastings until you get to Renfrew, then turn North onto Renfrew and it’s the first entrance on the right (Forum Gate 2). Park in the parking lot that is between the building and Renfew St (immediately to the right past the gate).
There will be a parking attendant at the gate; just tell them that you're here for the Vancouver Mini Maker Faire Maker meeting and they'll let you in without charge.
Buses 014, 016, 135, and 160 all stop on the corner of Hastings and Renfrew.