Welcome! Log In Create A New Profile

(solved)Print Head wont heat up past 22(solved)

Posted by PinGish

PinGish

(solved)Print Head wont heat up past 22(solved)
August 11, 2015 01:57AM

Registered: 8 years ago
Posts: 9

when using repetier-host my print head wont heat up past 22, but if i use Pronterface it heats up just fine. any ideas why ?

(solved)

Edited 1 time(s). Last edit at 08/12/2015 06:56PM by PinGish.

Reply Quote

Downunder35m

Re: (solved)Print Head wont heat up past 22(solved)
August 14, 2015 03:45PM

Registered: 8 years ago
Posts: 778

Very helpful to mark as solved without mentioning anything about how it was solved....

Reply Quote

PinGish

Re: (solved)Print Head wont heat up past 22(solved)
August 18, 2015 12:18AM

Registered: 8 years ago
Posts: 9

sorry about that. it ended up being my fault. when i was using the slicers and such i forgot to tell it to never try and heat the bed. needles to say .. i don't have a heated bed so it would never start heating the head or print.

Edited 1 time(s). Last edit at 08/18/2015 12:20AM by PinGish.