Jerky Y Axis During Printing
Posted by davidbitton
|
Jerky Y Axis During Printing March 06, 2016 04:21PM |
I'm having an issue with a jerky Y axis during printing. The bed moves back and forth fine using manual controls, but during printing, it jerks with every step. In the picture, you can see the sawtooth pattern in the supports. What would cause this to occur?
IMG_6391 by David Bitton, on Flickr
|
Re: Jerky Y Axis During Printing March 08, 2016 02:02PM |
i had that problem and it was the tension of the Y axis belt, give it a look 
Sorry, only registered users may post in this forum.