Hello,
After a long break I finally put the parts onto my Ender 5 - Duet 2 wifi board, Titan Aero hotend. I have taken a few days to familiarise myself with RepRap and the new Duet firmware. I thought I had got myself to a point where I could print a test cube and start to fine tune. However when ever I start the print the Z axis lowers itself to the bottom and tries to start the print at 0.003 instead of at the top 299.7.
I am using Cura 4.9. I have used an Ender 5 profile as well as a CFFF profile, but both give the same result.
Start Gcode :
G28 ;Home
G1 Z10.0 F6000 ;Move the platform down 15mm
;Prime the extruder
G92 E0
G1 F200 E3
G92 E0
Config: Attached
What am I missing?