swelling?

Here's a mendel multi colour mini extruder body I just printed I'm happy with the straight lines but if you look at the corner here where's it slightly pointed it's a bit horrible looking.

This was printed with 0.3mm layers, first layer at 30% speed then 40mm/s for perimeters and small perimeters and 60mm/s for infil, bridging at 30mm/s

First layer printer at 195c and others at 190c Bed at 65c throughout

I tried printing with a cooler first layer and the small bit at the top came unstuck.

Faberdashery space marine blue filament.

Thoughts?

Many Thanks

Ben

Just looks like its warped in that corner?

Warping is minimal really but my printer doesn't like even 45 degree overhangs the top of it's lovely.

Ben