Welcome! Log In Create A New Profile

Printing Layer Error : HELP PLZ!

Posted by Janski

Janski

Printing Layer Error : HELP PLZ!
April 26, 2014 12:35PM

Registered: 10 years ago
Posts: 96

So this happened:

Finally after getting the extruder to grip properly, the prints are doing this: along 2nd or 3rd layer the print unexpectedly slides over and continues in the incorrect position.

Please advise if anyone has encountered this issue smiling smiley

Sincerely,

Janski

Reply Quote

Janski

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 12:45PM

Registered: 10 years ago
Posts: 96

It basically moves the next layer up Y direction a few steps and continues to print proportionally to the move.

HELP!

Reply Quote

Janski

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 02:01PM

Registered: 10 years ago
Posts: 96

I have tightened the belts on Y axis and other axis. checked the 2560 board all looks find.

anyone think it is the driver?

too fast in Marlin?

Please advise

Reply Quote

MrDoctorDIV

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 02:17PM

Registered: 10 years ago
Posts: 790

Do you know how to adjust the current on your stepper drivers?
Sounds like they're skipping steps, a common and typically easily fixable issue. Turn the pots about 1/16 turn, clockwise, at a time until skipping stops.

Reply Quote

Janski

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 02:53PM

Registered: 10 years ago
Posts: 96

This process is not familiar to me. Can you explain? What are pots and 1/16turn is it the screw on the driver for Y axis? Turn left or right?

Thanks smiling smiley

Reply Quote

Janski

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 04:12PM

Registered: 10 years ago
Posts: 96

The Ramps 1.4 board i have has an extra dual drive.

I went and replaced the drivers from E2 to Y and uploaded the firmware.

The same results.

Can anyone explain to me what creates this behavior?

When I tried to print a Box it resulted in type of stairs.

Reply Quote

MrDoctorDIV

Re: Printing Layer Error : HELP PLZ!
April 26, 2014 09:25PM

Registered: 10 years ago
Posts: 790

Here is a good tutorial and full explanation that I wish I had found when I was looking to do this myself.

Reply Quote

Janski

Re: Printing Layer Error : HELP PLZ!
April 30, 2014 10:25AM

Registered: 10 years ago
Posts: 96

Thank you for the link and the explanation! I read through it and learned a lot about the potentiometers smiling smiley

After further investigation I found the pots were set correctly.

The problem was: y carriage belt was becoming loose due to lose fit on the belt clamp. After I tightened te mount and secured the belt, I no longer get the results show in pics above.

Thanks again. Always learning new things with this 3d printer smiling smiley