I've been printing a lot with my Prusa i3 but suddenly I got this strange behaviour.
The print stops after the initial start G-code, like heating up the bed and nozzle and also the "Custom Start G-code", including G29.
It looks like the program is waiting for the nozzle to get to it's chosen temperature even though it already reached that level.
The behaviour started a while after I activated auto bed levelling.
If I edit the g-code and set the first nozzle temp command, M104, to 5 degrees lower than the later M109 it will continue the printing as normal.
Can the PID settings have any influence on this? I did a "PID Autotune" before this behaviour arose. I can't understand how it could make this happen though.
Marlin version: 1.1.0-RC5
Printrun version: 2015.03.10
Slic3r version: 1.2.9
Grateful for any help make me understand this behaviour.
Edited 1 time(s). Last edit at 05/17/2016 02:27AM by kakbit.