My printer makes a squeezing sound on the motors and only x axis moves and the motor is extremely hot.
I used the Prussia Mendel_i3 marlin firmware early "Marlin firmware used for Prusa i3 Hephestos - modified for Prusa i3 Rework"
but it accept the job heats up, and when it about to start it stops and cools down.
Now i installed another version "for a Geeetech i3 X: [Firmware for Geeetech i3 X]"
and after i install when i tried it gives the above motor heating and some axis are not moving.
I follow the procedure from this site:
[
reprap.org]
Pleas help me.
Edited 2 time(s). Last edit at 01/30/2018 09:19AM by Rasyoni.