I finally finished fixing my old Mendel90. It received an SKR 1.4 Turbo, all new wiring, and most printed hardware was replaced due to cracks/wear.
The test cube prints however show some issues I don't recall seeing before.
The worst by far is the X.. it's clearly deformed and the left edge is strangely angled. The Z and Y look quite good, but I have some noticable Z-wobble and banding. Belts are tight enough.
Print was done in PLA, same stuff I've been using for a while. Any ideas or suggestions?
Image with 3 cubes showing the exact same pattern attached, as well as my Marlin config.
Edit with Benchy images. Strangely, those look very nice except for some wall seperation in the chimney and some small blobs.
Edited 1 time(s). Last edit at 08/06/2020 03:38AM by Arakon.
