Welcome! Log In Create A New Profile

Advanced

CTC Bizer Dual Extrusion not working

Posted by Joschi 
CTC Bizer Dual Extrusion not working
January 05, 2024 03:08PM
Hello,



I have an old CTC Bizer with dual extruder and Sailfish 7.7

Slicer: Makerbot Desktop; I couldn't get anything else to work

I did some test prints which were successful.



Now I wanted to do a two-color print.

I sliced an object in Makerbot Desktop and send it to the printer.



After heating, both extruders are primed succesfully.



THE PROBLEM:



It then moves to X until the end (on the side without an end stop) and doesn't stop.

Which causes the belts to skip to infinity.

With Single Extrusion it does this too, BUT after 2/3 jumps of the belt it notices and starts printing.



What can I do against it?
Re: CTC Bizer Dual Extrusion not working
October 25, 2024 07:25AM
I would recommend to check the end-position switch of the X-axis. Most likel it has been dislocated and does not trigger.


Sorry, only registered users may post in this forum.

Click here to login