Welcome! Log In Create A New Profile

Advanced

slic3r supports

Posted by keoflex 
Forum List Message List New Topic
keoflex
slic3r supports
April 26, 2013 05:52PM
What is the best way to configure slicer to handle support for printing overhangs. My current config is:

Thanks in advance
Reply Quote
tmorris9
Re: slic3r supports
April 27, 2013 08:40PM
With the newest version I just use the defaults, the program will try to figure out the best if you leave them at "0". The latest version will work pretty good with most prints with no adjustments.
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login