I'm using version 1.2.9 and am seeing an issue with the slicing. I'm slicing an extruded design that is admittedly thin. The last time I sliced it was with version 1.0.0 and it sliced fine.
What happens now is that I get a piece of the part missing because the slicer starts/stops on the print and they do not connect. They "almost" connect but don't. I'm wondering if someone has an idea on how to change it so that it slices properly? In version 1.0.0, it did the entire slice as a single non-stopping extrusion. In the new version it made it into two.
picture
Any ideas on how to get this to actually touch?
thanks
david